Home Forum The Makers Workshop 3D Print talk aurora z605 and ramps board

This topic contains 1 reply, has 1 voice, and was last updated by  Rob 4 years, 6 months ago.

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #2130

    gearcutter84
    Member

    Hi i bought an aurora z605 printer kit and got it going but the print laters we going crazy it had a melzi board, i was told to get a ramps 1.4 board which i have i have wited it up but nothing is working. Does anyone have any experience with this kind of printer or board cheers mike

    #2135

    Rob
    Participant

    I have not had any experience with the Melzi board, but from what I can see it has the MCU attached to the board. Atmel MCU running Marlin Firmware.

    To swap over to a RAMPS you will need an Arduino Mega and upload the Marlin firmware to get it running.
    You will also need to configure Marlin to use the RAMPS board.

    These two setups at the end of the day are very simular, and you may expreience the same problems with both setups if it is a configuration problem or software causing the problem.

    I have never had a hardware problem ( YET ), I usually find it is a configuration or post processor problem.

Viewing 2 posts - 1 through 2 (of 2 total)

You must be logged in to reply to this topic.